A service can be created underĭescription=Install quirks for DELL TypeC ethernet/VGA/ DA 200 adapter usbcore: registered new interface driver r8152ĮDIT: I tried googling "Tx status -71," and I have the feeling that this - which seems to be an unresolved bug - is relevant, though I'm not entirely sure how to implement the provided patch, or if that would solve the problem. I also ran dmesg for the driver these are the only two lines not already shown above: ~$ dmesg | grep r8152 IPv6: ADDRCONF(NETDEV_CHANGE): enx00e04c680050: link becomes ready IPv6: ADDRCONF(NETDEV_UP): enx00e04c680050: link is not ready Here's some of the output of dmesg there was a lot more, but it was all exactly the same. ![]() ~$ lsusbīus 002 Device 004: ID 0bda:8153 Realtek Semiconductor Corp.īus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hubīus 001 Device 003: ID 0cf3:e301 Atheros Communications, Inc.īus 001 Device 004: ID 0c45:6713 Microdiaīus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub The adapter interface is the first one, enx00e04c6880050. TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 TX errors 247 dropped 0 overruns 0 carrier 0 collisions 0 Here are the outputs of a few relevant commands: ~$ ifconfig I looked at several similar questions and didn't see an answer. I have not touched my network settings (everything is set to automatic), I know the USB port works (and is 3.0), I've switched out the ethernet cable, and I've rebooted, and the problem remains. Resetting the admin password of most LB-LINK routers is simple and requires pushing a reset button, located on the router itself, for 5 to 10 seconds.I recently bought a new ethernet adapter for my laptop, but it always fails to connect to the internet. How to reset LB-LINK router login password? Then check if you are connected either by using the Wi-Fi network or a LAN cable connected to a LAN-labelled port of the router.Ħ. The majority of the LB-LINK routers use 192.168.16.1 as the default IP addressįirst, type the router’s IP address in your browser address bar, Then, enter your router username and password, and then click OK or LOGIN.Ībove, you can find the most probable default credentials.įirst check if the WAN cable is connected to the correct port of the router which is labelled as “WAN”. ![]() What is the default IP of a LB-LINK router? ![]() The majority of the LB-LINK routers have the default password adminģ. What is the default password of a LB-LINK router? The majority of the LB-LINK routers have a default username of admin and a default password of adminĢ. What is the username and password of LB-LINK routers?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |